Grizzly Saw G4816 User Manual

G4816 G4817 G4818 G4819 Instructions  
1. Remove band saw blade per instructions in your manual.  
2. Remove both upper and lower blade guides.  
3. Install ball bearing guides in place of old guides.  
4. Re-install blade.  
5. Set the bearing guide so the bearing just clears the teeth of the blade. The blade will be damaged if  
the bearing comes in contact with the teeth during operation.  
6. Loosen both thumb screws on the upper bearing guide.  
7. Rotate each eccentric shaft until the bearing just touches the side of the blade. Tighten down the  
thumb screws. Make sure the bearing guides are not pinching the blade. This can cause premature  
bearing wear.  
8. Repeat steps 5-7 for the bottom bearing guide.  
9. If access to the thumb screws is limited or they interfere with a guard or bracket, replace them with  
hex bolts. Be sure not to over tighten!  
10. Reset the back-up bearing per the instructions in your bandsaw manual.  
Grizzly Industrial, Inc © 1996  
 

Graco GPS Receiver 285W User Manual
Haier TV DVD Combo HLC1 User Manual
Hamilton Beach Slow Cooker 840149600 User Manual
Havis Shields Automobile Accessories C CUP2 Series User Manual
Honeywell Thermostat Electronic Programmable Thermostat User Manual
Hotpoint Washer WF 566 P User Manual
HP Hewlett Packard Server 419195 002 User Manual
HTC PDAs Smartphones TRIN100 User Manual
Husqvarna Saw WS 440 HF User Manual
Icom Two Way Radio iF25 S User Manual